Latest News Posts

Social
Latest Forum Posts

NZXT Precise 650W
Bookmark and Share

nzxt_precise_logo.gif
Print
by Rob Williams on September 12, 2006 in Power Supplies

NZXT has impressed us quite a bit with their Lexa and Apollo cases, so we were looking forward to giving their entry into the PSU market a spin! It proves itself to be a supply worthy of your consideration, but is a wee bit overpriced.

Introduction

In the little time that NZXT has been around, they have made quite a splash in the PC case market. In a sense, they came out of nowhere. Usually companies start off slow and offer mundane products but that was not the case here. To date, I’ve reviewed two of their cases, the Lexa and Apollo. They received 9/10 and 10/10 scores, respectively. Today, both my primary PC’s still use those cases and I swear by them. So, needless to say NZXT made me a fan pretty quickly.

Like many other companies, NZXT took the natural step beyond their flagship products and decided on PSU’s. OCZ has been in the PSU business for a while, same with Thermaltake. But we see this ‘craze’ spreading like wildfire. Even Corsair and Mushkin recently launched a PSU line! Obviously, companies understand the need for big power supplies to feed our gaming rigs.

They have both a 550W and 650W version of the Precise, and we will be taking a look at the latter today. It is equipped with dual +12v rails, which should assure clean power to your CPU and other components. This is also becoming a fad, but is a sensible one… the more +12v rails, the better. There is even one on the market that includes five +12v’s, although that’s a little extreme ;-)

Here are the official features for the Precise:

  • Nvidia sli ready certified
  • Four sata connectors for more hard drive capacity
  • Built for stability and less ripple noise keeping your devices safe while maintaining low noise via 120mm cooling fan.
  • Combined power technology: automatic switching between standard dual +12v rails and combined power of both +12v rails.
  • Hush silent technology keeps noise quietly below 30 dba at full load.
  • Fully supports the rush power consumption of high frequency cpu & graphic cards.
  • +12v current increased to meet more peripheral devices and high-end cpu
  • Supports high end graphic card’s pci express requirements
  • +5vsb current up to 2.5a to fully support more usb 2.0 plug and play devices.
  • Industry standard protection: over voltage, current, short circuit, scan-disk-free, and voltage surge protection.
  • Stable regulation on +3.3v / +5v / +12b at 5%
    Input

  • AC Input Range: 1 15/230 Vac
  • Frequency: 60/50 Hz
  • Inrush Current: 30A/115Vac, 60A/230A
    Connectors

  • 24-Pin Motherboard
  • 8-Pin (Or 4-Pin) Motherboard
  • 2 6-Pin PCI-E
  • 3 4-Pin Fan
  • 3 3-Pin Fan
  • 4 S-ATA
  • 2 Floppy

There are a few things to note here. First, this is an SLI certified power supply, meaning it’s designed with those setups in mind. There’s also something they call “Combined Power Technology” which involves both of the +12v rails. If there is no need for a dual +12v, then it combines the power output of both… to essentially make it one with 40a.

Stable regulation is 5% on all rails, so we will see throughout our tests if that holds true. In place also are the usual protections you would expect, including under/over voltage and short circuit protection. Before we give the PSU a good stress, let’s take a quick look at the retail packaging and supply itself.


Page List:
Top

1. Introduction
2. Closer Look
3. Testing Methodology


  • David Header

    i have this psu in my pc that I built about four years ago, still runs great. however I recently had to open up the psu and flip the fan to reverse its flow. its bottom mounted, and was pulling hot down heating up my gpu which is mounted a few inches above the psu’s big fan. now the psu is blowing fresh cool air on my gpu allowing me to overclock it. now my 4 year old pc’s running better than ever. I’m even playin WOW at max settings maintaining around 38fps even in a 40man battleground like AV. I did attach and seal an air filter on the outside vent of the psu which is now sucking in air to keep it clean.

Advertisement