Enthusiast SSDs may get all of the fame and glory, but it’s the value brands that always sell the most drives. As a relative newcomer that doesn’t rely on SandForce controllers like many other vendors do, can SanDisk’s Marvell-equipped Ultra Plus deliver that “Ultra” good value we’re looking for?
At Techgage, we strive to make sure our results are as accurate and real-world applicable as possible. We list most of the steps and processes involved in setting up and conducting our benchmarking process below, but in the interests of brevity we can’t mention every last detail. If there is any pertinent information that we’ve inadvertently omitted or you have any thoughts, suggestions, or critiques, then please feel free to email us or post directly in our forums. This site exists for readers like you and we value your input.
The table below lists the hardware used in our current storage-testing machine, which remains unchanged throughout all of our testing, with the obvious exception of the storage device. Each drive used for the sake of comparison is also listed here.
|Techgage Solid-State Drive Test System|
|Processor||Intel Core i7-2600 – 3.80GHz (Locked) Quad-Core|
|Motherboard||ASUS P8P67 Deluxe|
|Memory||4GB Kingston DDR3-2133|
|Graphics||AMD Radeon HD 5770|
|Storage||Hitachi 7200RPM 2TB Hard Drive
Corsair Neutron GTX 240GB
Crucial m4 256GB
Intel 335 Series 180GB
Kingston HyperX 3K 240GB
Kingston SSDNow V300 240GB
OCZ Vector 256GB
OCZ Vertex 3.20 128GB
OCZ Vertex 4 256GB
SanDisk Ultra Plus 256GB
|Power Supply||Antec NeoHE 550W|
|Et cetera||Dell 2407WFP (1920×1200)
Windows 7 Ultimate SP1 64-bit
Our Windows 7 Desktop for SSD Testing
When preparing our SSD testbed for benchmarking we follow these guidelines:
Windows 7 Optimizations
For our new Sandy Bridge storage testbed we have migrated to using test images for our drives. All drives are imaged with the cloned test image to ensure all drivers, programs, and settings remain identical for testing purposes. We feel disk cloning software and SSD controller technology has matured to the point where potential issues such as non-aligned sectors are no longer a potential issue.
For testing, we run all tests five times dropping the highest and lowest results, then take the average of the middle three. And who said that college statistics class wouldn’t prove useful? If any anomalous results are seen the test will be run again. Given the complexities of modern computers, and especially today’s operating systems and the software that runs on them, we feel this provides the most accurate results possible.
Finally, we are seeking to constantly improve and expand upon our SSD testing methodology. We are always actively seeking real-world workload scenarios that are bottlenecked by hard drives, so if you have any suggestions whatsoever or there is a program you would like to see included in our SSD content, then please drop by our forums and let us know! We are always looking to expand our SSD benchmarks and provide more useful and real-world results, and not just synthetic numbers.