AMD HD 6950 1GB vs. NVIDIA GTX 560 Ti Overclocking

To test our graphics cards for both temperatures and power consumption, we utilize OCCT for the stress-testing, GPU-Z for the temperature monitoring, and a Kill-a-Watt for power monitoring. The Kill-a-Watt is plugged into its own socket, with only the PC connect to it.

As per our guidelines when benchmarking with Windows, when the room temperature is stable (and reasonable), the test machine is boot up and left to sit at the desktop until things are completely idle. Because we are running such a highly optimized PC, this normally takes one or two minutes. Once things are good to go, the idle wattage is noted, GPU-Z is started up to begin monitoring card temperatures, and OCCT is set up to begin stress-testing.

To push the cards we test to their absolute limit, we use OCCT in full-screen 2560×1600 mode, and allow it to run for 15 minutes, which includes a one minute lull at the start, and a four minute lull at the end. After about 5 minutes, we begin to monitor our Kill-a-Watt to record the max wattage.

In the case of dual-GPU configurations, we measure the temperature of the top graphics card, as in our tests, it’s usually the one to get the hottest. This could depend on GPU cooler design, however.

Note: Due to power-related changes NVIDIA made with the GTX 580 & GTX 570, we couldn’t run OCCT on that GPU. Rather, we had to use a run of the less-strenuous Heaven benchmark.

For whatever reason, our GTX 560 Ti overclocked card was a bit more forgiving when we tested it for temperatures than the stock-clocked version was, as it reaches the top of the chart – a good thing in this case. AMD’s overclocked card experienced just a minor gain in heat.

Power-wise, NVIDIA’s card drew 21W more at load, and AMD’s drew 26W. Given the performance boosts seen, these bumps in power draw might not matter too much to you.