Foxconn Winfast NF4UK8AA-8EKRS @ MBReview

“As far as the general layout and design of the NF4UK8AA-8EKRS goes, I’d have to say that Foxconn has done a good job. They eliminated any possible problems with loading and unloading RAM by placing the x1 PCI-E connectors above the x16. The heatsink on the nForce4 chipset could provide some better cooling, but in the case of elongated graphics cards this becomes impossible as the card will end up overlapping the heatsink. The main problem with the board is the floppy connector location. Granted the floppy isn’t used all that much, but it’s still an annoyance to have to spend more time routing a floppy cable than all other wires.”

Check out the full review at MBReview.